Kick Out Diverter Flashing . When flashing, one of the home or buildings biggest potential leak areas is where the eave (cornice) meets the vertical wall. It is best to err on the side of caution to control the flow of rain water and prevent leaks. Kick out flashing should be installed above the rain gutter, drip edge flashing and/or roof edge shingle mold where the roof meets the vertical wall or projection whether there are gutters or not. The term shingle mold is used even when other than shingle type roofing materials are present.

Shingle mold is usually a 1x. Shingle mold in some cases takes the place of metal drip edge or vise versa. In some cases both are installed. At least one or the other is there at the edge of your roof, fastened to the fascia whether you have gutters or not.

Kickout flashing helps with or without gutters. The 2. 00. 9 Internation Residential Code (IRC) has a section detailing side wall flashing: . Without  properly installed kickout diverter flashing rain water can penetrate in behind the siding or masonry and get trapped inside the wall. The lack of kickout flashing or incorrectly installed kickout flashings are often the source of major structural problems, mold issues, rot damage and can be the feeding ground for termite infiltration.

Roof flashing materials can be classified into two primary groups: membrane and sheetmetal. Ice and water barriers and roll roofing are membranes. Application instructions PRECISION 38, 76 AND 190 SERIES PRIMED PANEL SIDING INCLUDING SILVERTECH & SMARTFINISH General Here at ProMaster Home Repair & Handyman of Cincinnati, we.

To Install Stucco Right, Include an Air Gap How should stucco be installed to avoid the wall-rot problems plaguing thousands of U.S.

Omitting the needed kick out flashings almost always leads to in many cases serious damage inside the enclosed wall and wood framing behind the exterior cladding. Sometimes this damage is totally concealed until the exterior is opened up or until major signs become apparent.

This image shows damage caused by the lack of proper kickout flashing at the necessary area which is marked above in red. Rain water was not diverted away and excessive moisture seeped inside the wall causing excessive damage inside of it. The San Antonio area Home Inspection (below) in the Leon Valley area shows a lack of proper kick out flashing along with a gap behind the minimal flashing present as seen at the yellow arrow. Repairs have been attempted as seen by the streaks of black from roofing tar that was applied.

The yellow squared area in photo does show the deterioration, rotting due to the improper flashing in the area above. KICK- OUT FLASHING IMAGES Yellow arrow above shows the area that proper kickout flashing was needed and not present. Images to right show the proper installation of kickout flashing at different types of exterior wall claddings, including brick, stucco, siding and stone.

Siding and stucco wall flashing is behind the cladding while the flashing on stone and brick leading to the kickout is on the exterior of the cladding and should have a counter flashing over the base flashing. See images below:           Images show proper roof flashing at masonry over roofing.

At right shows the base flashing at siding over the roof tying into the kickout flashing. Siding is up 2. Flashing is under siding as needed and also goes under stucco type cladding. He Brought Me Through Hard Trials Lyrics To Despacito. Siding and stucco serve as the counter flashing over the base flashing. The photo at right with siding is before roof materials were installed.

The shingles as were to be used on this house will go over the bottom area of flashing that is on decking after underlayment was first installed. A Home Inspector should know where proper flashing, including the important kickout (diverter) flashing should be located and what common defects to look for while inspecting a home's exterior relating to it.